Something like that; i want some control, only clock if possible, from a daw, when Md is on ports 1 in/out and MnM on the two 2-ports.
How do i clock them from a daw when no port is available?
Theoretically, if MCL runs on 9v power, the USB port could be used for an extra midi port. Would be THE best use for it actually!
After looking at the code… I think I was lying – it says IN ISR but in fact it’s just a looped task.
Edit: it’s been written month ago – it’s indeed running in the ISR but it’s still way too loose.
Test results confirm it, can use the MD clock to the DAW but it’s all over the place.
Yes, I am aiming for this or even more preferable, a PC/Daw-less solution, as in having a Midi-Masterkey+Faderbank to control MD and MnM via CC.
Sofar this works very pleasant with only MD+MCL which is great!
Bi-directional midi correspondance of port 1 and 2 would open up possibilities to Control MnM and MD from In-2 with the downside of MnM only being connected to the Out-Port 2.
Understood.
Actually, with MegaCom you can already go DAW-less – simply select your real midi device instead of a virtual “MegaCommandPortX”, and you’ll be connecting MD/MnM to the device.
For now I just want to make sure that this whole setup would be good enough on PC(software megacom)-MC. If it works, we can then develop a low cost USB host, hardware MegaCom.
I know, fingers just slipped.
Actually i thought it was with an E for quite some time until i learned what was right and now it´s hard to un-learn. So i might happen again if i´m not focused. Just sayin´.
Ah, please don’t feel discouraged! It’s just a quick sketch of a non-existing prototype.
It would definitely make more sense if the addons can be modularized so you can daisy chain multiple.