hey there
I´m a new OT owner,
just want help with a very simple question
how do I set 32 or 64 bars loop ?
reading the manual but it is a little bit confusing on this…
thanks!
Hey ain’t, 16 steps equals 1 bar or measure in general but isn’t the rule, thus 64 steps equates to 4 measures. These steps are set in the Scale Setup [Function+Scale Setup]. In general but again not the rule, the Master Scale should reflect the length of the individual track length, thus 64 track steps equals 64 master scale steps. Just to befuddle the issue further you can also setup individual track scales [Function+Bank] - Scale Mode Per Track. Then there’s Multipliers…
Hold down “Function” and press the bottom far right button labeled “1:4 2:4 3:4 4:4” then adjust from there to get 64/64 which is 64 steps, not 64 bars.
And on a side note, you HAVE TO at least read through the manual while checking out the functions, and watch all the tutorial videos in order to understand how to work the OT completely. Otherwise good luck.
Here’s everything you’ll need to watch:
Have fun.
Hold Function and press Scale button (bottom right of OT) - this brings up the Scale Menu.
Then press Scale button again (on its own) to toggle through 16/32/48/64 steps.
Finally, press Exit or Function + Scale button again to leave Scale setup.
Now, when in record mode, pressing the Scale button toggles through the pages of the pattern.
If you had Trigs on the first page before changing the length of the pattern, they will be copied onto the other pages by default. (You can change this behaviour in the settings).