OSC1 out of tune

Hey y’all. The first oscillator on my AK is sharp about a quarter tone. It was fine one day and then off the next… I ran through the calibration after letting it warm up a few hours and it stayed exactly the same. I can use fine tune to get it right and the scaling is fine, but I can’t figure out what’s going on. I don’t have anything in the cv in/out either. Could there be some other setting I’m missing?

Have you checked if you have a Performance macro on your Kit ?

Yup, no macros! From a blank project and init patch it’s out of tune.

just oscillator ou of tune ?

load a new project after saving your current project. then report back …