Two tier acrylic stand and NEW: Elektron MK1 and MK2 + Ableton Push Stand

WARNING!!! ALWAYS CHECK HOW DEEP BOLTS CAN GO INSIDE YOUR MACHINE BEFORE SCREW THEM ON THE STAND.

It seems that in some machines using long bolts can arm your control board: Link

EDITED: Analog Four + Push stand pictures added.

My new two tier stand just got laser cutted.
I use a MOTU Ultra lite interface and a MOTU Microexpress, the stand councils both interfaces below the machines.

Find the blueprints here:
https://www.dropbox.com/s/fz3y97xjp4krti7/Low%20Profile%20Acrylic%20Stands%20for%20Elektron%20by%20Gustavo%20Bravetti.zip?dl=1

And the new Mk2 that still need a couple of finé tuning.

Best!

12 Likes

Beautiful :thup:

Beautiful Stand
Where can I order it?
What’s the price

I can give you the files so you can go directly to any acrylic laser cutter and do it by yourself :slight_smile:
If there are a couple of acrylic laser plotters here in Uruguay I bet you will find some at your city, don’t you?

Btw it costed me about 40 usd for the two pieces in 5mm acrylic.

Just let me know.

Best!

2 Likes

Tnx!

Hi
Thanks for your Answer
Please give me the Files
I’ll see who can make me

Big Thanks for

Greetings

Hi Gustavo

did you forget me :slight_smile:

Please send me the Files

Greetings

Sorry, I just returned.

Wich machines you will put on the stand?

Nice design work!

thanks!

Hi
Thanks for Answer
Analog Rtym and Analog Four put on the Stand

Check you inbox!

And send me pictures when ready. :slight_smile:

Looks great. What length of bolts did you use with the 5mm acrylic?

I think 12mm with a 0.5 mm washer. May be it would be better a bit smaller bolt, like 10mm.

1 Like

May I have the blueprints too? :slight_smile: I’d be using A4 and Machinedrum :slight_smile:

1 Like

Hey hcxcy:

Can you give me this measures for the MD.

1 Like

WARNING!!! ALWAYS CHECK HOW DEEP BOLTS CAN GO INSIDE YOUR MACHINE BEFORE SCREW THEM ON THE STAND.

It seems that in some machines using long bolts can arm your control board: Link

1 Like

Please check this also regarding bolts length Link

1 Like

Hi, Can I have a copy of the blue prints I have an analog rytm and an octatrack.

Thanks

You have to use your Octatrack on the upper floor, is that ok with you?