I just bought the Digitakt. Lucky me! But when using headphones with it I don’t get any sound. Stupid me!
I’m sure there’s an easy solution. Anyone help?
Have you tried other headphones?
My headphones work with my other equipment (op1 and mixers etc) but I will try other headphones on your advice. Thanks mate
There’s Master Volume Level (everything), Track Level (per track) and Amp Level (per sound).
The connector between OP-1 and DT is not the same, could be the adapter.
Try a new empty project, load samples / preview them.
Don’t forget to read the f… manual
Do you hear sound from the main outs, but not headphones? Or no sound whatsoever?
The overbridge / audio routing might be setup weird if it’s a 2nd hand device.
I clicked on this topic title hoping to see the new launch of a TX6-sized battery powered Digitakt
Again if it’s a second-hand device, you might also check the INT TO MAIN setting, which some folks who use USB setups sometimes turn to off (turns off MAIN and Headphones out for audio interface purposes).
This is most likely the issue. Go to Settings>Audio Routing>Make sure all them trigs are green