I’m still on 1.10
When using the microtiming menu, I’m occasionally seeing the “cursor” jump around.
It seems to happen when the sequencer is active.
I’ll do more testing to figure it out.
Also, sometimes when selecting LFO destinations for LFO1, LFO2’s page when show up.
At this point I’m pretty sure one of my encoders is twitching a bit on it’s own or it’s just a bug. I’ve not noticed it happening anywhere else though.
Anyone else experiencing this? Gonna make a support ticket tonight
An OS update to 1.20 might fix the issue. Have you tried this yet? Plus you get Portamento as a bonus.
I saw people complaining about the dsp boot issue increasing or showing up so I hadn’t done it yet. I will tonight though
I used to get DSP boot error on 1.10 much more than on 1.20. That is only my experience, it could be different for others. DSP boot error is nothing too major from what I’ve encountered, a quick power cycle and you’re back in business.
I believe there is a diagnostic mode on the Digitone that you could try out as well. Can’t remember how to access it though.
A Jumpy knob is likely a hardware problem. My digitakt has a jumpy d encoder and exhibits the same behavior. There have been a few cases mentioned here on the forum. Solution was to Contact support.
Ah yes, the diagnostic menu. I had to do that on my OT for the cross fader.
Thanks for the reminder!