Filter cutoff jumping when tweaking while in Control All mode?

Elektron Gear Model:Samples
#1

Hi guys!

I’m kinda new to the M:S. Only few hours playing with it and I realized that if I parameter lock the filter cutoff frequency for certain trigs for a certain track, when I tweak the filter cutoff knob while the pattern is playing and holding the Control All button, the cutoff frequency suddenly jumps back to the locked value in that track. I understand the reason but is there a way to avoid this jumping? I would like to tweak the cutoff frequency as if it is a global filter applied to all tracks. Hope I explained well enough.

Thanks a lot!

#2

I don’t own a M:S but I have a Digitakt and the behaviour is the same, so the quick answer is no. But a work around would be to assign the cutoff to the LFO and use a one shot saw or exponential wave, then plock the depth. This way the cutoff frequency will remain relative. Hope that helps.

1 Like
#3

@DEEPMOSES, thanks for the tip! Will try!

Regards