I´d like to control/automate the Delays parameters bei the DNs own miditracks and CCs.
i managed it to control the “time” parameter of the Delay by the according CC from a miditrack of the DN. Which means my settings were ok.
But i have no chance to control the “Feedback” and also the “hi-pass/low pass” Filter.
only the Delay time responds to the CC sent from the DN itself. the other three parameters not.
??? something mixed up in the Manual ??? unfinished FW ???
Just for reverence and your information. parts of the CC chart for the delay:
Delay Time: CC15
Feedback: CC18
Highpass Filter: CC72
Lowpass Filter: CC73
i used those numbers.
its manual page 79
not donne this so far with the DT. so no clue how its there
Aha, sorry, to early for me (!) didn’t understand that these do not register in the DN… Check if you can reproduce this in a blank new project and open a support ticket to elektron?
yeah, latest version. my CC assignement was right me thinks.
the strange this is that i did the same on the DT also, and i could not arrive.
couldn´t get to control the delay from the midi track in my DT.
must check again…other people can do it.
but it would be nice to know if you guys get to control all parameters.
internal miditrack vs. Delay ? ( DN or/and DT )
I’ve been trying to use my DT midi out to control the global fx parameters on Digitone and not having much luck. A tutorial would be really good. I’m sending cc data on fxchannel 9 from DT but not noticing any changes on the Digitone. Are animations disabled on fx params?
no luck here. i use FX chanel 9 and just tryed other combinations also.
( well, first without a midi cable, haha. fixed it )
would be nice to know if its me or not.
but i have no clue where my fault would lie.
Same problem here. in fact I can’t seem to get it working for all FX pages and master pages. The individual tracks fx work perfect though. Attempted through external hardware (MidiFighters Twister, M-Audio Code 49), through the Digitakt’s Midi channels and via Ableton. Nada.
