It definitely works better but my unit still gets warm, mostly on the right side and under the knobs. Is this normal? If not where can I find a proper power supply?
I think it’s normal for units to get a little warm, especially on the side where the psu enters. However what’s warm to one person might be lukewarm to another, kinda hard to say. Especially since it was powered with an out of spec psu before that, it’s not unlikely that something got damaged.
Just out of interest, after 40 minutes with the previous psu the machinedrum would shut down, freeze, or become too hot to touch?
Also might be good to check how many amps that psu can deliver, I couldn’t find this on the amazon page. If the MD is underpowered, I don’t think it would get hot but the psu probably will get hot. Does the cable from the psu to the MD also feel hot along its length?