Mapping Lauchkey mk3 to Digitakt and Digitone (only hardware)

Elektron Gear Other Elektron Gear
#1

Hello,
i am amateur with this, but i want to mapping this, if anyone can help me or give some advance, i really apreciate, This is the way:

Lauchkey Mini mk3:

Knob 1 to Ch3 Digitakt to SRC - Length
Knob 2 to Ch3 Digitakt to SRC - Loop
Knob 3 to Ch3 Digitakt to AMP - Hold
Knob 4 to Ch3 Digitakt to AMP - Decay Time

Knob 5 to Ch1 Digitone to FLTR - FREQ
Knob 6 to Ch2 Digitone to AMP - CHR
Knob 7 to Ch3 Digitone to SRC - DEL
Knob 8 to Ch4 Digitone to SRC - REV

PADS (16all) To Ch3 Digitakt (I want to make kit percussion inside this channel)

Keyboard (all) to Ch4 Digitone

It is posible?

Thanks Anyway,

Lucare

#2

You’ll need something to change usb to midi plug - Kenton and Midi Solutions make some. Not sure if there is a cc editor but the Launch Control does.

#3

No USB host needed, as the Launchkey mini mk3 does type-A MIDI over minijack as discussed here: https://www.elektronauts.com/t/launchkey-mini-mk3-compatible-with-digitakt/

This setup should be possible with the Novation components editor, you can at least set the MIDI channel separately for the pads. Not sure about setting it separately for each knob, though.

#4

Hi, yes i buy this cable:

And i put the same channel midi, all the sync part correctn i update today de LKmk3, but for the moment nothing happen…

#5

I think maybe the problem is this cable…