Hi,
When I change patterns on my AR the A4 lags behind one cycle of 16 steps.
On both devices and all patterns I have set CHNG to 16 and LEN to 1024
What am I doing wrong here?
Here’s a video.
Hi,
When I change patterns on my AR the A4 lags behind one cycle of 16 steps.
On both devices and all patterns I have set CHNG to 16 and LEN to 1024
What am I doing wrong here?
Here’s a video.
I started a discussion on this a week or two back, you’ll find it in the search with the info about where I was up to with this issue.
A key for me to sorting it out was starting 2 fresh projects for each device and making sure all the settings were correct on each device… it’s worked fine for me since.
Here;
So I stumbled across this thread, and I think I know what’s causing this. I just put in a ticket and the team got back to me saying this:
A known bug can cause patterns to change too late if the receiving device is in advanced scale mode and have a master length that is higher than 16. We are working on a fix for this problem.
So there we go - either use simple pattern length mode on the A4 or set the master length to 16. I always have the master length set to 128 because I use polymeter a lot so I ran into this problem pretty much immediately. Hopefully they fix it soon.