Hello!
So, those Autechre SysEx files had me get to my MM again. I haven’t used it in a while…
Now, I keep getting this problem here:
Setup is:
MD sends Clock and Transport directly to MM.
MM is set to receive both.
Alright, so far, so good, works nice.
But now, I have problems with the MM sequencer.
Even when I set MM Clock to Internal, and Transport to Ignore again, I can’t enter recording mode.
Record LED doesn’t light up, and when I use the Transport buttons (Rec, Start, Stop), they act as if I was doing Track Page Copy. But I am not holding anything else while pressing them.
The sequencer remains unresponsive until I turn the MM off and on again, or when I load another Snapshot.
I must be in some mode here that I forgot about? But I can’t find anything in the manual.
Anyone know what this is?
Thanks a lot