Hi all!
Do you know if it possible to send out a sync signal from the Analogue 4 Mk II to the Korg SQ 1 so that when I press play on the A4, the SQ 1 also starts?
Thanks!
caveat below
easy - just set up a number of cv trigs
there are too many ways to do this to repeat (it’s been covered a lot in discussions over time)
But it’s very straightforward, it depends how funky you want to get with the clocking (i.e. trig conditions or not, probability, but beyond that it’s easy to do, just make sure you know what the voltage a given cable is using maxes out at)
The SQ1 side MAY involve a cable being present in the sync in, such that it halts transport until a signal is sent - this may well compromise tempo detection depending on the step to trig ratio which may be 1/2 1 or 2 (possibly) - so would work most robustly with 1:1
Haven’t tried, might be wrong, but many sync devices will play ball with this kind of setup