My Syntakt always loads the factory project when I power it on instead of the last project I was working on. It also won’t save my global LED brightness settings. I change them to mid, but every time I power it on, they are back to max brightness.
My other Elektron devices will load the last project I was working on, and it says in the Syntakt manual that this one should, too. I’ve looked through all the settings and can’t find anything that might be wrong. I’ve also perused the forum and can’t seem to find anything about this issue.
I’m running the latest firmware, I’ve even done a factory reset and re-installed the latest firmware (1.01) and this hasn’t fixed it.
Anyone else experiencing this?
I sent a support ticket to Elektron, but I wanted to throw this into the forum and see what happens. I’ll post an update when I hear back from the Elektron team.
Any thoughts?