Hey all, I’m currently using this stand:
and I like it. A4 on top, and two digis on the bottom. Any recommendation for three digis on the bottom? I haven’t found much in the forum, even though there must be a lot people having a similar configuration (like, Octa, DT, DN, AH etc. …).
Find some wood and do it yourself: you’ll get the perfect stand that matches your needs 
I don’t have tools and no fingers to loose 
I believe the attention it takes to operate all these electronic devices is a good indicator that you could safely operate a hand saw, pencil, straight edge, drill and screwdriver!
If your current stand is screwed together you would only need to make two new decks that were wide enough. You could just replace the existing decks.
1/4 plywood, wood glue would likely be all the materials. Tool can be borrowed. And I’d be happy to help anyone figure out what to build.
Don’t you have friends that could help?
The hardest part is to design it so that you can access the rear.
Here is what I did.
If I had to redo it I would elevate it of at least 20 cm.
I can write down some plans if you wish.
I would really appreciate those plans!
SO dope.
OK. Does someone have an idea which tool I should use to do this quick and clean?
